In the setpg / PCI interface dialog box, you can use the install / remove interface dialog box to install or remove the communication interface on the computer.

1. In the setpg / PCI interface dialog box, click to access the install / remove interface dialog box. The available interfaces are listed in the selection box, and the installed interfaces on the computer are displayed in the installation box

2. To add an interface: select the communication hardware installed on the computer and click Install. When the install / remove interface dialog box is closed, the interface is displayed in the interface parameter used box in the setpg / PCI interface dialog box.

3. To delete an interface: select the interface to delete and click the delete button. After closing the install / remove dialog box, the interface will be removed from the interface parameter used box in the setpg / PCI interface dialog box.

  

Figure 1 setpg / PC interface and install / remove interface dialog box

  

There is a slight difference between installing hardware modules in Windows NT and in Windows 95. Although the hardware modules are the same. It needs more hardware knowledge to install under Windows NT. Windows 95 automatically sets up system resources for you, which cannot be used in Windows NT. Windows NT can only provide default values, which do not necessarily match the hardware configuration. However, these parameters can be easily modified to match all required system settings when the hardware is installed.

Select the hardware you want to install from the installation list and click the resources button. The resources dialog box appears, which allows you to modify the system settings for the actual hardware you are installing. If the button is invalid (gray), no modification is required.

Leave a Reply

Your email address will not be published. Required fields are marked *