The 754/754PLUS Multifunction Process Calibrator is a powerful multifunction documenting process calibrator that lets you download software-created programs, lists, and instructions, or upload data for printing, archiving, and analysis. The 754/754PLUS also features a powerful HART interface built in, with which you can now use this interface for nearly all of the daily tasks you perform through a single communicator.

● The language operating system has been upgraded in an all-round way, providing a simple and friendly Chinese operation interface, which is more convenient for Chinese users to operate, and greatly improves the work efficiency of professionals for on-site calibration and fault diagnosis.

● Measure voltage, current (mA), RTDs, thermocouples, frequency and resistance to test sensors, transmitters and other instruments.

● Source/analog voltage, current (mA), thermocouple, RTD, frequency, resistance, and pressure to calibrate transmitters.

● While the thermal signal calibrator measures current, it provides loop power for the transmitter during the test.

● Use one of Fluke's 29 700Pxx pressure modules to measure/source pressure.

● Create and run automated pre/post calibration procedures to meet quality plans or regulations. Record results and archive.

● Store downloaded programs and calibration results for up to a week.

● Thermal signal calibrator has various functions, such as automatic stepping, self-defining unit, user input value during the test, single-point and double-point switch test, square root DP flow test, programmable delay and so on.

● Easy to use.

● Three-year warranty.

● High brightness dual display.

● Read output parameters and measurement parameters at the same time.

● The NiMH rechargeable battery can be used continuously for 10 hours. Contains a gas pressure gauge.

● Handle fast pulsed RTD transmitters and PLCs with pulses as short as 1 ms.

● Thermal signal calibrator with DPC/Track sampling software.

● Compatible with various asset management software packages.

HART function:

The Fluke 754/754PLUS Multifunction Process Calibrator can do almost all the daily tasks you now perform through a single communicator. In fact, it provides the communication capabilities of the 275 HART Communicator.

● No external protective case or other tools are required for routine HART calibration and maintenance.

● Thermal signal calibrator provides fast HART communication.

● Supports common HART transmitter models with more device-specific command support than any other HART field calibrator.

● Multi-master, burst mode, and multi-branch configurations are available.

● Easy to update as additional instruments are added and new HART versions are released.

● Challenge to determine device type, manufacturer, model, label.

● Reconfigure sensor mapping for dual sensor temperature transmitters.

● Read HART PV function and smart transmitter digital output, and measure analog mA output at the same time.

● Read and write HART configuration functions to make field adjustments to PV range points, attenuation, and other top-level configuration settings.

● The thermal signal calibrator re-tags the smart transmitter by reading and writing the HART tag field.

Responsible editor: gt

Tagged:

Leave a Reply

Your email address will not be published. Required fields are marked *